What is UDECX?
UDECX Modular Deck Systems
What are the components of UDECX made of?
The UDECX composite deck surface pads are made of polypropylene, a thermoplastic polymer resin, via a compression molding process. A fiberglass infill has been added to provide additional structural support and a UV inhibitor helps protect the surface from damage caused by exposure to the sun. The piers, shims and risers are made from 100% recycled polypropylene resin with talc added for additional strength thereby ensuring years of worry free use.
How "green" is UDECX?
UDECX is committed to doing its part to safeguard the environment. In addition to our components being recyclable, when possible we’ve used recycled resins to create our components. UDECX also reduces the environmental impact of adding a deck by not requiring a sub-frame or treated lumber with associated health risks, not to mention waste going to a landfill. One of the best features of UDECX is that it is reusable; you can take it with you when you move or reconfigure it, meaning it never becomes obsolete.
Can I take it apart and relocate it?
Yes, the UDECX system is designed to come apart just as easily as it goes together. The modular design allows you to relocate, reconfigure or expand the deck easily.
Once it is installed can I buy additional pieces and expand it?
Yes, all UDECX components are designed to allow for easy expansion. If you install a kit this year you can buy additional components in the future to expand you deck to change with your lifestyle.
What happens if it settles over time?
UDECX has been designed to accommodate all soil conditions including clay, gravel, topsoil and even sand. If you do due notice settling in the deck, the modular design allows you to remove the pads in just the affected area and raise the piers either by adding soil or the use of one of our risers or shims to re-level the piers, reinstall the pads and you’re done.
Do I need a permit?
In most municipalities a permit is not required to install the UDECX system since it is generally smaller than 300 sf, less than 30″ off the ground and is not permanently bolted or otherwise attached to the home. You should check with your local building department to see if they would require a permit.
Can I make other shapes besides a square patio?
Yes you can! The basic building block of the UDECX system is a 40″ x 40″ square pad that comes in one of two color choices, Flint Grey or Cedar Red. Using this basic square building block, you can build almost countless configurations (think Legos!) Visit our Design Center for just a few examples of the practically unlimited different configurations that you can build with UDECX.
If I buy additional pieces in a year will they fit my existing UDECX patio deck?
Yes, components are designed to work together and the modular system insures that future components will work with existing kits. The color of the existing deck will have faded slightly so the new pads may be slightly off in color. Most fading occurs the first year, so after a year or two the color will be very close to matching between the old and the new.
How much prep work of the ground is required?
When installing the UDECX patio deck the piers need to be level with each other. You can level the grade at each pier location by using a 4 ft. level spanning between the piers to insure that all piers are level prior to installing the pads and cam-locks. Each starter kit includes (12) 1″ shims and (4) 3″ riser blocks, these allow for you to adjust for uneven ground.
How can I measure how tall the risers need to be to make it level?
Consider using string and a string level. With the string 6″ above the ground at the house you can stretch the string to where the deck will be at the low end and then measure down to see how high it will be off the ground.
What is the weight of a kit?
A kit weighs approximately 460 lbs. When you have it shipped to your home from one of our retailers it will generally be dropped at the end of a driveway or other curbside area. Simply open the packaging and carry the components individually to where you intend to install your deck. The heaviest components are the surface pads that weigh about 40 lbs. each.
Is it safe for all BBQ grills?
Yes, UDECX is similar to other component decking products, as long as there is sufficient space between the grill and the UDECX surface there isn’t an issue. UDECX recommends using a grill mat to prevent staining of the surface from grease or other debris.
How strong is the UDECX system?
UDECX has been engineered to support 100 psf, this is more than double the load requirement per code for most of the US.
How is the system secured to the ground?
Each UDECX starter kit includes a 12″ steel spike for each pier to secure it to the ground. We also offer 18″ spike if you use more than 6″ of shims and risers in combination. We recommend using 18″ spike where ever you have a railing post as well.
What if any, are the issues with water and freezing, is the product rated for a freezing temps?
The UDECX pads each have a small crown to them that allows for water to drain to the edge of the pad and the small gap between pads allows for water to drain from the surface. Because UDECX is designed with a “floating” foundation there should not be an issue with freezing and thawing of the ground as long as the system is not directly secured to the home or other structure. The entire deck will move with the ground. If there are any areas of settling these can be easily addressed by re-leveling the piers in the affected areas.
What maintenance is required?
We recommend cleaning you UDECX patio deck once a year with water and a brush or broom. A mild detergent can be used as well if there is staining from leaves or other debris. We do not recommend using a pressure washer as this could damage the surface texture of the pads.
What is the UDECX warranty?
UDECX components are guaranteed against faulty manufacturing for a period of three years from the date of purchase and covered for stain and fade for a period of 15 years from the date of purchase.
Can I use my new patio deck immediately after installation?
Yes, with UDECX you can “Imagine in the morning and Enjoy in the evening”.
What skill level is required to install a UDECX patio deck?
The system was designed to make it a very friendly DIY project, even for a novice. The modular system means there is no cutting, sawing or drilling. The only tools you need are a shovel to level the ground at the pier locations, a hammer for securing the pier top the ground with the included spikes and a level to insure the piers are aligned prior to installing the surface pads. The kit includes a hand tool for securing the cam-locks.